Assembly variants |
||
Rear wall assembly with normal construction width The THERMOVENT will be mounted with two stainless steel panels with solid polyamide blocks on the warm side of the wall above the door opening. This is the normal type of installation. |
||
Rear wall assembly with reduction of the construction width The THERMOVENT will be mounted with two stainless steel brackets on the wall above the door opening. These consoles take up less space in the construction width - but need more space in the height |
||
Rear wall assembly with variable console distance The THERMOVENT is mounted with two stainless steel brackets with solid polyamide blocks on the warm side of the wall above the door opening. If you can not mount the brackets in the right distance, it can be corrected by shifting the angle brackets below the polyamide blocks. |
||
Ceiling mounting with mounting under the ceiling The THERMOVENT will be mounted with two stainless steel brackets under the ceiling above the door opening. |
||
Side mounting with mounting on the side walls The THERMOVENT will be mounted with two stainless steel panels with polyamide solid plates on the side walls and in front of the door opening. This type of installation is often used in corridors that are sealed off by air curtains against warm air loss. |